We use cookies to ensure that we give you the best experience on our website and to improve the relevance of our communications with you. If you agree and continue we’ll assume that you are happy to receive all cookies and you are granting us and our service providers your consent to set cookies on your computer.
More Information
Cut the MAINPEX composite pipe to length at a right angle using the corresponding original tool by MAINCOR.
2. Expand
Then push the sliding sleeve over the pipe which is not widened yet. Plug the pipe end to the stop on the expansion head to widen the pipe by compressing the expansion caliper to the mechanical stop.
3. Stick on
Then the pipe has to be moved over the whole fitting profile and the sliding sleeve positioned to the widened pipe end.
4. Sliding
Afterwards insert the pipe with the fitting into the sliding tool. Take notice of the correct sliding jaws. The sliding procedure is finished as the sleeve is slided on the pipe as far as it will go.
1. Cut
Cut the MAINPEX composite pipe to length at a right angle using the corresponding original tool by MAINCOR.
2. Expand
Then push the sliding sleeve over the pipe which is not widened yet. Plug the pipe end to the stop on the expansion head to widen the pipe by compressing the expansion caliper to the mechanical stop.
3. Stick on
Then the pipe has to be moved over the whole fitting profile and the sliding sleeve positioned to the widened pipe end.
4. Sliding
Afterwards insert the pipe with the fitting into the sliding tool. Take notice of the correct sliding jaws. The sliding procedure is finished as the sleeve is slided on the pipe as far as it will go.
Properties
Properties
Tight, without sealing ring
Sleeve can be used on both sides
10 years extended warranty
100% oxygen-tight
Dim. 16 - 50
Also available as bars, pre-insulated and pipe-in-pipe